MIC5200-5.0YM-TR
The MIC5200 is an efficient linear voltage regulator with very low dropout voltage (typically 17mV at light loads and 200mV at 100mA) and very low ground current (1mA at 100mA output), offering better than 1% initial accuracy with a logic-compatible on/off switching input. Designed especially for handheld battery powered devices, the MIC5200 is switched by a CMOS- or TTL-compatible logic signal. The enable control may be tied directly to VIN if unneeded. When disabled, power consumption drops nearly to zero. The ground current of the MIC5200 increases only slightly in dropout, further prolonging battery life. Key MIC5200 features include protection against reversed battery, current limiting, and over-temperature shutdown.
The MIC5200 is available in several fixed voltage and accuracy configurations.
MIC5200是一款高效的线性稳压器,具有极低的压差(轻负载时通常为17mV,100mA时通常为200mV)和极低的接地电流(100mA输出时为1mA),初始精度优于1%,具有逻辑兼容的开/关切换输入。MIC5200专为手持式电池供电设备设计,通过CMOS或TTL兼容逻辑信号进行切换。使能控制可以直接连接到V在…里如果不需要。禁用时,功耗几乎降至零。MIC5200的接地电流在压差下仅略有增加,进一步延长了电池寿命。MIC5200的主要特性包括电池反向保护、电流限制和过温关断。
MIC5200提供多种固定电压和精度配置。
Product Features 产品特性
Parametrics 参数化
Product Type | Single LDOs |
# of Out | 1 |
IOUT #1 | 100 |
Rated IOUT | 100 |
VIN Min (V) | 2.5 |
VIN Max (V) | 26 |
VOUT (V) | 3.0, 3.3, 4.8, 5.0 |
Voltage Drop Typ (mV) | 230 |
IGND Typ (µA) | 130 |
Tol Typ % | ±1 |
Noise (µV) rms | 100 |
PSRR 1 kHz (dB) | 70 |
Rev Bat | Yes |
产品类型 | 单通道LDO |
出去的次数 | 1 |
IOUT #1 | 100 |
额定IOUT | 100 |
VIN最小值(V) | 2.5 |
VIN最大值(V) | 26 |
VOUT(伏) | 3.0, 3.3, 4.8, 5.0 |
电压降典型值(mV) | 230 |
IGND典型值(A) | 130 |
公差类型% | 一 |
噪声(V)均方根值 | 100 |
PSRR 1千赫(分贝) | 70 |
Rev蝙蝠 | 是 |
MIC5200-5.0YM-TR
The MIC5200 is an efficient linear voltage regulator with very low dropout voltage (typically 17mV at light loads and 200mV at 100mA) and very low ground current (1mA at 100mA output), offering better than 1% initial accuracy with a logic-compatible on/off switching input. Designed especially for handheld battery powered devices, the MIC5200 is switched by a CMOS- or TTL-compatible logic signal. The enable control may be tied directly to VIN if unneeded. When disabled, power consumption drops nearly to zero. The ground current of the MIC5200 increases only slightly in dropout, further prolonging battery life. Key MIC5200 features include protection against reversed battery, current limiting, and over-temperature shutdown.
The MIC5200 is available in several fixed voltage and accuracy configurations.
MIC5200是一款高效的线性稳压器,具有极低的压差(轻负载时通常为17mV,100mA时通常为200mV)和极低的接地电流(100mA输出时为1mA),初始精度优于1%,具有逻辑兼容的开/关切换输入。MIC5200专为手持式电池供电设备设计,通过CMOS或TTL兼容逻辑信号进行切换。使能控制可以直接连接到V在…里如果不需要。禁用时,功耗几乎降至零。MIC5200的接地电流在压差下仅略有增加,进一步延长了电池寿命。MIC5200的主要特性包括电池反向保护、电流限制和过温关断。
MIC5200提供多种固定电压和精度配置。
Product Features 产品特性
Parametrics 参数化
Product Type | Single LDOs |
# of Out | 1 |
IOUT #1 | 100 |
Rated IOUT | 100 |
VIN Min (V) | 2.5 |
VIN Max (V) | 26 |
VOUT (V) | 3.0, 3.3, 4.8, 5.0 |
Voltage Drop Typ (mV) | 230 |
IGND Typ (µA) | 130 |
Tol Typ % | ±1 |
Noise (µV) rms | 100 |
PSRR 1 kHz (dB) | 70 |
Rev Bat | Yes |
产品类型 | 单通道LDO |
出去的次数 | 1 |
IOUT #1 | 100 |
额定IOUT | 100 |
VIN最小值(V) | 2.5 |
VIN最大值(V) | 26 |
VOUT(伏) | 3.0, 3.3, 4.8, 5.0 |
电压降典型值(mV) | 230 |
IGND典型值(A) | 130 |
公差类型% | 一 |
噪声(V)均方根值 | 100 |
PSRR 1千赫(分贝) | 70 |
Rev蝙蝠 | 是 |